DC Motor Drive Module 7A 160W 12V/24V PWM H-bridge L298 Logic Control Board
RWF 16,000
Product Description
- Power supply voltage 6.5V-27V, power supply must not be connected to or over 27V, otherwise it may burn out the module, it is recommended that the power input in series 15A fuse.
Dual motor interface, each rated output current 7A, peak current 50A, the motor interface must not short-circuit, the proposed series 10A fuse.
Control signal voltage 3-6.5V, respectively, is the enable signal and the positive inversion control signal.
Enable signal terminal (ENA) input PWM adjustable speed, PWM frequency range 0-10KHZ, PWM minimum pulse width 10us.
Working temperature -25 ? -80 ?.
Product size: 55 x 55 x 16mm (length and width).
Installation hole diameter: 3mm, attention should be paid to prevent short circuit on the back of the circuit, you can add insulation pad or copper column to raise the circuit board. - Suitable for motor parameters:
- Rated voltage 24V of the motor, the appropriate identification of rated power 115W and below or rated current of 7A or less the following long-term work of the motor.
Rated voltage 12V of the motor, the appropriate identification of rated power 40W and below or rated current 7A rated below the motor for a long time full of work.
Related Products
L298N Motor Driver
RWF 4,000
FF-280PB DC Motor 6-12v
RWF 2,000
NEMA 17 42 Stepper Motor 17HS4...
RWF 17,000
L293D Motor Controller Driver
RWF 1,500